PEDALTRAIN DAYLIGHT OVERDRIVE PEDAL

Pedaltrain introduces Daylight Overdrive and Nightlight Distortion

• Two brand-new, all-original circuits
• Discover new sounds and textures 
• Both pedals are very dynamic, touch sensitive, and clean up beautifully
• Responsive to your guitar's input volume and picking attack
• True bypass
• Switchcraft Jacks
• Made in USA

We designed this pedal to work well with various guitar and amp combinations, using every combination we could think of... vintage, boutique, budget, etc. Then, we spent a year sharing the pedals with session players in Nashville. This is the final product, and we like it a lot!

The controls are simple, just three knobs. Start with each control at 12:00 (high noon), and then experiment. We worked hard to make sure the 12:00 setting was a good starting place out of the box. 

• Level: Level controls the volume of the output.
• Tone: Tone controls the darkness/brightness of the tone.
• Drive: Drive controls the amount of overdrive/distortion.

Specifications

• Made in the USA.
• Designed, built and tested in Nashville, Tennessee.
• True Bypass Switching. The devices use standard mechanical true-bypass switching. Audio will pass through if the switch is turned off, and/or if there is no power to the pedal.
• Switchcraft jacks
• 9V only. External power supply required. Power supply not included. There is no battery clip inside.
• 9-Volt DC power supply with a 2.1mm center-negative barrel connector.
• Current Draw: Less than 10 mA
• (9v) DC power only. Do not run at higher voltages. 
• Length x Width x Height (incl. sockets, knobs, etc.): 4.92” x 2.62” x 2.23” (125 mm x 66.5 mm x 56.6 mm)