RADIAL ENGINEERING PZ-DI ORCHESTRAL INSTRUMENT DI R800 3005 00

Variable Load Active DI with Piezo Optimized Input
The PZ-DI™ is an active direct box that has been designed for acoustic and orchestral instruments, with a variable load that allows you to set the optimal input impedance for your pickups for more natural-sounding results.

- Optimized for orchestral instruments on a live stage
- Adjustable load for piezo and magnetic pickups
- Variable low-cut filter to control low frequency resonance
- Powered by 48V phantom, no batteries required

Piezo problem solver
The PZ-DI has a variable load selector switch that allows you to set the input impedance of the direct box, so you can optimize the performance with your instrument's pickups. The 1 meg ohm position delivers the classic impedance found on most active DI boxes, while the 220k ohm setting warms up the tone of magnetic pickups to provide the feel and tone as if your instrument were connected directly to an amplifier. The third setting is an ultra-high 10 meg ohm impedance that is specifically designed for piezo transducers, helping compensate for the harsh or squawky tone that can occur when a piezo is connected to a lower impedance input.

Variable filter to suit any instrument
To remove unwanted resonance on stage and prevent feedback, the PZ-DI is equipped with a fully-variable low-cut filter that gently rolls off low frequencies. The roll-off point of this filter can be raised or lowered to match the frequency response of your instrument, with a lower point for acoustic bass and a higher setting for violin or banjo. A switchable high-cut filter is also included, which is useful on instruments such as acoustic guitars that incorporate a battery-powered preamp, softening any harshness or high frequency edge for a smoother tone.

PZ-DI Applications
Using the PZ-DI with a piezo
Piezo pickups often sound harsh and unnatural. The PZ-DI solves the problem with a 10 meg-ohm input impedance that extends the frequency response and smoothes out the peaky edges. Adjust the low-cut filter to size the instrument and reduce unwanted resonance.

Using the PZ-DI with active acoustics
The convenience of a built-in pickup and battery powered preamp makes it easy to plug-in and play. But with less than ideal electronics, these instruments end to sound brittle and unnatural. The PZ-DI helps with a low-pass filter that gently smoothes the top end plus a variable low-cut filter to eliminate resonance.

Using the PZ-DI with a magnetic pickup
Optimize the tone of the bass by setting the load to 220k-ohm. This produces a warmer tone and natural feel that is particularly useful when recording or when preparing to Reamp. When touring with low-output vintage instruments, set the impedance to 1 meg-ohm to reduce the load.

Specifications
Audio circuit type: Proprietary analog circuit with low-noise FET op-amp
Frequency response: 20Hz ~ 20kHz
Dynamic range: 105dB
Gain: +4.6dB
Total harmonic distortion: 0.02%
Input Impedance: 10M/1M/220K-Ohms
Output Impedance: 200 Ohms - nominal
Equivalent Input Noise: -98dBu

Features
Input pad
Input Connectors: 1/4" hi-Z input
Output Connectors: XLR male output

General
Construction: 48V phantom - proprietary digital switching
Weight: 1.2lb (0.54kg)
Shipping size (L x W x D): 127 x 84 x 48mm (5.0" x 3.3" x 2")
Power: 48V phantom - proprietary digital switching
Conditions: For use in dry locations only between 5°C and 40°C
Warranty: Radial 3-year, transferable